Why after cleaned the carburetor and changed the flow and the needle the tractor start with choke but don't stay on and hard to start again?
Usually when the tip on the needle valve is red, it's no good.
Why are you making a video of you don't know what you are doing?
and the point of this video is??
The shut off solenoid does not stop fuel flow to the bowl. It shuts off fuel to the main jet tube in order to prevent backfires when the key is turned off. The only thing that stops fuel flow to the bowl is the float needle pressing against the needle seat or the fuel shut off valve if one is installed.
did you figure out what was wrong?
mines flooding too, gonna try replacing the needle/seat
Push out the main jet from behind (out of the plastic housing). There is an oring around that jet. Check its condition. If the oring is bad the new jet is $20.You can't buy the oring separately. Check the schematic. It's hard to see, but it's off to the right of the carb diagram.
I have this model, this was good to see it open before I take mine apart.
Your email address will not be published. Required fields are marked *
Save my name, email, and website in this browser for the next time I comment.