7 thoughts on “Briggs and Stratton 11 hp governor question for donyboy73

  1. @donyboy73 I have verified that all linkages and springs are correct. I'll make a video and upload it later today of the linkages and carb.

  2. i have seen some go in freely and others a bit tighter, i don't think that is your problem though. i would have to physically see all the linkages and carb to give you a better answer.

  3. What happens when you "spin" the old governor gear assy on the shaft? Do the counterweights and plunger react normally? OK, watched the video again, plunger does NOT not react freely when the old governor gear is spun….

  4. What happens when you "spin" the old governor gear assy on the shaft? Do the counterweights and plunger react normally?

Leave a Reply

Your email address will not be published. Required fields are marked *