21 thoughts on “Briggs and Stratton 3.5HP Horizontal Linkage

  1. I'm about to tackle my first one of these carb rebuilds for a friend. What size torx tool do you use to remove the diaphram cover. Thanks.

  2. Thanks a lot for the video…I did not take a "before" photo of the linkage and had mine all screwed up. Briggs website was not helpful and you saved the day..

  3. Thanks, now in my seventies, couldn't remember how the springs connected up even though I just took it apart. Thank god for You Tube!

  4. Thanks so much for all the help! Do you by chance know the number for the other spring on the anchor? I damaged it and was hoping you may know since I can't find the number diagram.

    Thanks

  5. Just what I needed to confirm my setup after the carb rebuild. I had taken pictures of the linkages with my phone, but the phone was stolen before the rebuild was done!

  6. Awesome. Thanks for also including part numbers; this is exactly the type of info I need to get my woodchipper back up and running.

  7. Hello Thanks a lot for the video.
    I need to change the gaskets and the diaphragm of my concrete machine which have a Briggs&Stratton 3,5 Hp Horizontal Linkage modele:91232 Type:1363 E1 Code:980513FA.Do you know the numbers for the gaskets diaphragm kit

  8. Hello was wondering if there's anyway to removing that type of governor , have that same engine was just trying to find out how to set up a throttle for a minibike/gokart

  9. i have an engine just like this one. it only goes one speed but i would like to modify it so that i would be able to adjust the throttle like on older models. Do you think thats possible?

  10. You make the "BEST VIDEOS" ever, thank you. My 3.5 B&S model 91212 021901(with some other #981024) has the same type choke & throttle holder EXCEPT the choke is on top and the throttle is on the bottom  AND of course I did not take a picture and the  choke goes back on correctly BUT I can't get the little pull spring on the throttle leaver correctly. I have no book or diagram that shows the correct hook up. Any help would be appreciated.  My email address is mvwjsw@charter.net. Thanks in advance for your help.

Leave a Reply

Your email address will not be published. Required fields are marked *