6 thoughts on “Briggs and Stratton Governor Part 2

  1. Thank you very much, I'm one the guys asking you for carb linkage help… got it all squared away now, my old bs19 problem was the idle and jet screws. I had to back them out 3 full turns before it would even think about cranking….now it sounds like a beast

  2. Other cures for the worn throttle arm hole for the throttle arm pivot hole are twofold;
    1:your local machine shop (NAPA) can insert a hollow brass rivet into the hole*,
    2. or you can either braze, or solder (90/10) the hole closed and then re-drill the hole to be SLIGHTLY larger than the diameter of the throttle rod.(save a trip into town)
    * simular to the one in the throttle arm. being brass, it is less likely to wear. Of course a small drop of oil, or lithium grease will aid in that respect**
    Can't wait to see the innards of this mechanism!
    ** don't forget to add this to your periodic lube list!
    "keep 'em clean, keep 'em lubricated, KEEP 'EM LONGER"

Leave a Reply

Your email address will not be published. Required fields are marked *