Briggs & Stratton 8HP Model 19 Throttle / Governor Linkages



Showing how the throttle and governor linkages are setup on a older 8HP Briggs and Stratton. Thanks for Watching!!!

8HP Up Draft Carburetor Adjustment

Small Engine Governor Adjustment


source

(4)

3 thoughts on “Briggs & Stratton 8HP Model 19 Throttle / Governor Linkages

  1. The old 8 horse I/C on the Roof mower still runs like a Swiss watch as do all the 'L' heads but the 4 horse on the Snapper. The governor setup is 2 piece with one hooked to the shaft and a 1/4 inch bolt through the arm slot that goes to the carb. I turned it all the way to the right but the bottom fitting hooked to the shaft is in a notch in the case and can't move. That made it worse. It has an auto choke without the vacuum deal. It's on the breather hose going into the carb from the crankcase. I'm going to have to move it back because it runs plumb crazy the way it is now. It's a 110902-391101-85040404. I have no idea what to do but what I did. Thanks and good video. The square nylon green slider is the one I had to drill to hook the throttle back to the 11 horse on the old Craftsman., Pick me one!

Leave a Reply

Your email address will not be published. Required fields are marked *