20 thoughts on “Briggs & Stratton No Spark Problem

  1. Good idea to check this ground wire when coil and plug are known to be good. By the way, I agree with you and always take the time to sand residue off contact surface of coil and flywheel.

  2. question: i have a 3hp B&S and and i have no spark, one wire goes from the coil to the points, one to the sparkplug but i dont know where the third wire has to go.

  3. My riding mower will only start if I jump the two bottom posts on the starter solenoid. When I remove the jump it dies. It wont do anything with the key, and it's a new ignition switch. I will shut off with the key if I leave the jump and turn it off. Any ideas?

  4. We think the same in regards to cleaning the coil and flywheel.
    That being said, I usually set the gap at 10 thousandth on pushmower. Guess I never worked on the same engine as the one in the video

Leave a Reply

Your email address will not be published. Required fields are marked *