Briggs & Stratton Riding Lawn Mower Engine Carburetor #591736

This video provides step-by-step repair instructions for replacing the carburetor on a Briggs and Stratton small engine. The most common reasons for replacing the carburetor are when the engine is hard to start, stops after a few seconds, runs poorly, leaks gas, or won’t start at all.

Click here to buy part #591736:

Additional small engine repair, troubleshooting tips, help with finding your model number and part replacement videos can be found on our website:

All of the information for this carburetor replacement video is applicable to the following brands:
Briggs & Stratton, Toro

Tools needed: 1/4 inch socket or nut driver, 3/8th inch socket or nut driver, 7/16th inch socket, 5/16th inch wrench

Connect With Us!

Join our free VIP email list for discounts and money-saving tips:
Check out our blog:

Don’t forget to like and comment on this video, and subscribe to our channel!



3 thoughts on “Briggs & Stratton Riding Lawn Mower Engine Carburetor #591736

  1. I have a question. I removed the Briggs & Stratton engine off my Craftsman YT3000 mower to replace the leaking oil pump O ring on the bottom of the engine. Upon reassembly, I've hit a snag. Next to the oil filter is the solenoid (jus like the one in this video). A connector with a black and white wire connect to the bottom of the solenoid. The black wire with the eyelet connector gets bolted to the engine just above and behind the solenoid. My question is, where does the other black wire on the solenoid wiring harness get connected to????? I don't remember, nor can I find an obvious connecting point. PLEASE help me???

Leave a Reply

Your email address will not be published. Required fields are marked *