Read this before customising your engine:
Making any changes to your engine is at your own risk. We are not responsible for any damages done to your engine.
This video will show you how to connect a direct throttle after removing the governor from a 4 stroke 9HP stationary engine. The procedure is simple and may be done to other stationary engines as well. This is recommended for performance purposes only.
Please like and subscribe for further updates.
Shen Performance.
source
(33)
My friend, you’re a genius……..
awesome! thanks for the great vid sir!
good video but my Coleman 200u 196cc motor the works total opposite. if I hooked it like you did when you gave it throttle it would be taking it back to idle stop. wish this one have worked with mine. governor not working inside case. so stays wide open the way it is. good video though.
Thanks for your video…made it much easier for me to follow your directions…so what did you do with the governor arm ? …..just remove it and left the bolt sticking out of engine ??
Also connect a spring to governor in closed position because if it gets lose then the center piece of governor gear inside motor will fall out in engine and the governer rod hand will hit the crank..so don't let the governor remain lose.
Excellent tutorial – subbed!
What bracket did u use for the cable?
Where did you get that throttle cable bracket?
como instalo el pneamatic acelator y como trabaja
Вот бы русские такое сделали видео…
i did this on my preditor 212 do i have to take out the govenor in side motor to great videos
Finally, a helpful video! Good job!
hi, what happns if i do this without removing the govener inside the engine. would it buypass the govoner?
check out the videos in my channel people, they suck major balls… and don't forget to like share and subscribe!!
Good demonstration Shen, that is good information.
Can the kill switch get locked in the off position due to corrosion, age, or moisture causing the engine coil to not cause spark?
Can the kill switch get locked in the off position due to corrosion, age, or moisture causing the engine coil to not cause spark?
What if you just remove governor linkage and leave it in there?
how to connect the tail lamp with the engine of briggs and stratton 127 cc engine
That motor looks like my 13hp engine but it's blue thanks for the help
I am making a minibike, when i removed the Governor and put on the direct throttle this makes it a very short movement to full throttle is there any way to make this longer???
Thank you for that excellent video! It contains all the information I needed. Good job, Sir.
Good video. Okay just one more time please to make sure I get it right…how long is the throttle rod in the middle between the bends (or in the middle section) on each end? Thank you.
Fantastic video, thankyou
Thank you very much
Do you have to remove the mechanical side of the governor for this mod to work ?
Doesn't the govenor close the throttle plate ?
Ok so I did the direct linkage on the engine exactly like in this video and when I start the engine it goes full throttle once the choke if off. If the choke is on however it shuts off completely. Same experience?
great job THANK YOU