How to Replace a Briggs & Stratton Starter Clutch



How to Replace a Briggs & Stratton Starter Clutch.
Briggs & Stratton Starter Clutch PART #399671.
How to repair a puill start lawnmower..
Fix a Pull Start on a Lawnmower

lawnmower small engine repair..
Briggs & Stratton repair

source

(1)

5 thoughts on “How to Replace a Briggs & Stratton Starter Clutch

  1. Great video man it definitely helped me out although the ball bearing catch design in mine is less advanced and more annoying, and good tip with the brake and screwdriver method!

  2. Excellent video. Thank you!

    When I heard the magic words, "without any special tools" I think I squealed a little bit.

    I'm going to try fixing mine first, but if I must get a replacement, it's nice to know it's pretty easy to remove and replace. The inside of my clutch looks like it's all cast metal, rather than plastic separating the bearing channels. This is original equipment from a Briggs and Stratton equipped Monkey Wards mower, so pretty old. I recently had the deck repaired at the welder, rather than get a new one, because all the new ones look like the mounting for the front wheels are plastic. That can't last very long.

    Any idea what the diameter of the ball bearings is?

  3. Bad advice. That clutch is what holds your flywheel in place. Don't put anti seize on it. In fact put loctite on it if you put anything on it.

Leave a Reply

Your email address will not be published. Required fields are marked *