Poulan Pro 27 Inch Snow Thrower/Snow blower Carburetor Rebuild



Poulan Pro 27 Inch Snow Thrower/Snow blower Carburetor Rebuild
This is another one that had the gas left in the carburetor, the gas tank must have been empty because they refueled it and the gas in the tank looked good. But they should have drained the fuel bowl.

This video was made as a demonstration how to repair things and should not be done with out the proper training and safety equipment. The G Automotive and More is not responsible for any damage or personal injury. Please if you don’t have the ability to do these demonstrations, don’t try and get a professional to do it for you.

source

(1)

5 thoughts on “Poulan Pro 27 Inch Snow Thrower/Snow blower Carburetor Rebuild

  1. Pretty nasty for a new looking machine I find the drives suck I think the belt gets stuck you have to run it around 3 at least I have to clean my carb it’s nasty it sets outside covered for two years so it is needing a little rust removal I have a little shed I’m going to try to fit it in ther out of elements

  2. Very similar to my powersmart snowblower with the 208 cc engine. Great video!!
    How do you get the brass emulsion valve out? I was able to unscrew the bottom piece but the top piece doesn’t wanna come out.

Leave a Reply

Your email address will not be published. Required fields are marked *