Replacing Throttle Controls and Setting Throttle Cable On Older MTD Mower, Similar on Any



Video on showing how to replace throttle control and setting throttle cable on a older MTD Montgomery Ward mower, but this is pretty much the same on any small engine / mower / tiller / chipper / log splitter / etc. Thanks for Watching!!!

source

(3)

12 thoughts on “Replacing Throttle Controls and Setting Throttle Cable On Older MTD Mower, Similar on Any

  1. What did you mean about cutting the cable. Let's day the cable is too long. First of have to cut the outside spring. Then the inside cable?

  2. the throttle cable on my jd 116 is broken; i'm not sure i'm capable of replacing it; the engine surges but runs; I've fastened it down in the full throttle position; is this eventually going to cause a problem?

  3. question: i do my own work on my mower.one thing i cant seem to figure out (probably a fast and easy fix) is how do i fix throttle on my huskee riding mower? whether it goes up and or down,doesnt matter,its stuck on the same high speed.

  4. question on the throttle. when you shift it does it controlled two valves to the left. one for fuel and the other air?

    my ransomes mower is a mess and this is the first video I have seen the same design. I have a lever that connects to an air valve just laying there, looks like it needs to connect to the throttle.

  5. Thank you for the video. I didn't think I could put a different throttle but now I know I can. Thanks again and God bless you.

Leave a Reply

Your email address will not be published. Required fields are marked *