Small Engine Repair: Honda GX31 Carburetor Installation and Fuel Line and Fuel Filter Replacement



Visit https://www.thesmallengineshop.net

**Always follow the instructions in your repair manual when doing repair or maintenance work on Outdoor Power Equipment. Manuals can be found at the manufacturers website.**

In this video I reinstall the carburetor on a Honda GX31 engine, and install new fuel lines and fuel filter.

Thank you for watching!

source

(3)

11 thoughts on “Small Engine Repair: Honda GX31 Carburetor Installation and Fuel Line and Fuel Filter Replacement

  1. Thanks for the conclusion of that repair. Looks like no "H" and "L" screws, so no adjusting the carb (with the exception of the needle lever height?) Also what Walbro kit did you use? I guess there's two commonly used carb kits and was wondering if that may be one of them? Keep up the great work and always enjoy the videos.

  2. Great video question for you where do you find the factory speck info ie. how long the fuel line needs to be outside the tank etc thank you

  3. expert trimmer repairman told me that my motor is a  worthless and very bad chinese replica of this hona gx 31 motor ,but looks almost the same,  l notice mine does not have white letters on the red plastic over oil cap and the black area on top is different, mine has five slits. my oil cap is black too,

  4. THANKS! Very good you stated the lengths of the fuel lines from Honda, and how muchy they should stick out.. I have a gx35 multi tool machine and after 10 months thrashing, it likes to cut out when on angles lately, which it previously never did. I'm going to try new lines and filter and thanx to your specs info hopefully itll behave when cutting hedges and snipping on angles! Cheers

Leave a Reply

Your email address will not be published. Required fields are marked *