HOW TO Easily Start Your Generator (Chinese Honda Clone) After Many Months In Storage



Having problems starting your chinese generator after many months in storage? This video shows you HOW TO Start Up Your Chinese Generator After Many Months In Storage. ALSO TIPS FOR STORING IT.
This is a Honda clone engine so same procedure can be applied to a Honda as well.

source

(6)

Governor Adjustment and How They Work Honda Briggs Tecumseh Kohler etc.



how to adjust the governor on a small engine and how the governor system works
-small engine tachometer: http://www.amazon.com/gp/product/B00F2B80YK?ie=UTF8&camp=1789&creativeASIN=B00F2B80YK&linkCode=xm2&tag=sixtyfivefo05-20

SURGING ENGINE: This is a dirty carb, not the governor.

99% of all snowblowers, tillers, generators, log splitters, pressure washers and other equipment are designed to run safely run @ 3600 rpm max.

Mowers engines are designed and can easily handle a max of 3600rpm…However lawnmower blade speeds are goverment regulated and since the blade is directly connected to the engine they are sometimes limited to speeds closer to 3200rpm. Check your mower mfg for specs. Some mower manufactures lower the rpm only to reduce noise from the engine.

source

(5)

Small Engine Repair: How to Remove a Flywheel from a Kohler V-twin Engine using a Puller



Visit http://www.thesmallengineshop.net

**Always follow the instructions in your repair manual when doing repair or maintenance work on Outdoor Power Equipment. Manuals can be found at the manufacturers website.**

When removing a flywheel from a Kohler V-twin engine, Kohler recommends using a strap wrench to hold the flywheel to remove the flywheel bolt, and when tightening a puller to pop the flywheel off the engine crankshaft. It is possible to use a air or electric impact wrench, which would allow the flywheel to be removed without a strap wrench, but Kohler recommends not using an impact wrench. The method used in this video to remove the flywheel can be used on other small industrial engines.

Thank you for watching!

source

(1)

Setting Crankshaft & Camshaft timing on most Industrial Honda, Briggs & Stratton, Tecumseh Engines



Visit http://www.thesmallengineshop.net

**Always follow the instructions in your repair manual when doing repair or maintenance work on Outdoor Power Equipment. Manuals can be found at the manufacturers website.**

On most single cylinder industrial engines the camshaft gear is driven directly by the crankshaft gear. On each gear is a mark that must line up with each other for the camshaft to be timed correctly with the crankshaft. If the marks are not aligned, than the engine will not run correctly or will not start at all.

Thank you for watching!

source

(1)