HOW TO TROUBLESHOOT a GENERATOR that WON’T START or RUN – BRIGGS and STRATTON 10 Horsepower engine



10 Horsepower BRIGGS and STRATTON Engine on a GENERATOR. A BLOWN HEAD GASKET is DAGNOSED and FIXED. Torque Specs and HEAD BOLT Tightening specifications, sequence and procedure.
music by my band BonZaiRod “Staging Lane”

source

(7)

1979 Hayter Hayterette



my 1979 Hayter Hayterette Professional with a 1979 Briggs And Stratton 5hp (13cu)

Anyone Other Than Lovers Of Lawnmowers Will Say That This Is Boring.

Engine is a 1979 5hp I/C

131922 0131 01 79031506

When I purchased this mower last year (2015) it was a non runner)

It was partially seized – exhaust box rotten – deck was nearly black and covered in old old grass – blades were blunt and bent – points were nasty all i did was clean and gap them – head was coked up – air cooling fins were all blocked with oily grassy muck – undoing one of the exhaust studs inadvertantly snapped one of them. i intend on drilling it out and putting a quieter exhaust box on eventually. The previous owner was the original owner.

The serial number is not visible it must have been repainted at some stage.

I have always liked the original 5hp big block 🙂 (13 model series) the sound at idle etc reminds me of harley davidson motorcycles 🙂

Any Questions Please ask.

source

(2)

LAWNMOWER LEAKING GAS? Briggs and Stratton CARBURETOR FUEL INLET – FUEL LINE Connector ELBOW



Carburetor LEAKING GAS from the FUEL LINE INLET FUEL ELBOW CONNECTOR? Fuel line Connection at the carburetor leaking. Replacing a Briggs and Stratton CARBURETOR Fuel Hose Inlet Connector. SAME PROCEDURE FOR MOST SMALL ENGINE CARBURETORS!!!

source

(0)

Removing inlet needle seat and hose connector on a briggs carb



Has this ever happened to you ? / You deside your going to take out you lawnmower from winter storage. Only to try to start it and the engine grunts and wines but will not turn over to start. [Don’t feel bad its a problem I can help with ] You see whats happened is the old gas from the year past has went bad and done its damage on your carb needle and seat . Yes they can be a headace to repair but in the following video I will explain how to replace both the fuel inlet seat and hose connector . Also its not a bad idea to purchase a in line fuel shut off valve to give you peace of mind. But if your engine gets used regularly you should make it a rule of mind to [Check your oil level] each time you start your mower . I mention this because gas from your tank can find its way threw the carb[flooding ] the oil sump or crankcase. By checking the oil level you can determine if your engine oil smells like gas. If it should smell like gas then more than likely you have a flooded crankcase and that’s why your engine wont start. Simply drain you oil /gas mix and replace your oil filter if you have one .Also remove your spark plug and turn the engine over to expel any gas that could be trapped in your cylinder . ……..NOTE…..Remove your hood if you can the gas being pushed out of the cylinder can make a nasty mess.

source

(1)

#1Taking apart and rebuilding a small engine series



First part of a series on tearing down and rebuilding a small engine.
Visit us at http://www.lonergancompany.com/gifts-books–projects.html.

source

(1)

Briggs and Stratton 7HP Engine Rebuild Restoration | Part 4



Briggs and Stratton 7hp flathead (L-Head) ride on lawnmower engine rebuild. I fully restore this 7hp engine through this 4 part series. SUBSCRIBE – http://goo.gl/4aGnGF

source

(1)