Tecumseh Governor and Carburetor Linkage – Horizontal Shaft



Governor and carburetor linkage found on Tecumseh horizontal shaft engines.

5HP, 7HP, 8HP and 10HP

http://4strokerebuild.blogspot.com/

SBLG43 does not guarantee against unauthorized modifications of this information or improper use of this information. Due to factors beyond the control of SBLG43, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. SBLG43 assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. SBLG43 recommends safe practices when working with power tools, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Any injury, damage or loss that may result from improper use of these tools, equipment or the information contained in this video is the sole responsibility of the user and not SBLG43.

source

(7)

6 thoughts on “Tecumseh Governor and Carburetor Linkage – Horizontal Shaft

  1. Oh… it never ends… My incandescent headlamp just went out on my Bolens 824. It dies while it was on during the only night time use I've ever done… at the worst possible time. The bulb did not blow and I don't see a fuse anywhere. I wired in a LED tractor light with no results. Any ideas?

  2. Wow… the older I get, the less I know. I looked at this vid for a few days because I couldn't understand what I had done after my carb rebuild that made the linkage so screwed up. It finally dawned on me today after viewing this once again that I had the throttle arm hanging down instead of up- where it needs to be. I couldn't understand why the arm was rubbing against the throttle cable shroud, then my mistake finally hit me. I removed the carb and repositioned the governor linkages so the arm is up. All is good now. 

    You keep saying "thanks for watching", and I appreciate that, but more so… I want to sincerely thank you for making these videos. I've learned a lot from all of them.  If you ever have a guitar-related issue, please don't hesitate to ask.

Leave a Reply

Your email address will not be published. Required fields are marked *