Tecumseh HSK70 Rebuild – Part 17 – Sump Cover Installation



This is part 17 in a series of rebuilding a Tecumseh HSK70. This engine ran short on oil and the connecting rod blew.

Tecumseh HSK70 – 130292U
Simplicity 755E Snow Thrower

http://4strokerebuild.blogspot.com/

SBLG43 does not guarantee against unauthorized modifications of this information or improper use of this information. Due to factors beyond the control of SBLG43, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. SBLG43 assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. SBLG43 recommends safe practices when working with power tools, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Any injury, damage or loss that may result from improper use of these tools, equipment or the information contained in this video is the sole responsibility of the user and not SBLG43.

source

(3)

2 thoughts on “Tecumseh HSK70 Rebuild – Part 17 – Sump Cover Installation

  1. Thank you for this video, I used it as a guide this morning to replace the sump cover gasket on an HMSK90

  2. For lubricating things on the engine like the oil seal and metal could i use regular grease? I know silicone paste is better but i cant get that right now and have grease,its a budget build…

Leave a Reply

Your email address will not be published. Required fields are marked *